About Ro Installation Services

The water is generally filtered with a 5-micron sediment pre-filter and is next filtered by a carbon block or granular activated carbon (GAC) filter (or both), before it is processed by the reverse osmosis membrane (the contaminants are literally separated from the water by the membrane and flushed down the drain). Next, the clean water is sent to a storage tank (typically 2-4 gallons in size) where it is available for use. Whenever water is called for, it passes through a post-filter of GAC to remove any unwanted tastes and is polished to an even higher quality. Most systems are also equipped with an automatic shut-off valve (ASOV), which stops the flow of water to the drain, when the tank is full.

Originally, RO systems were designed to fit under a kitchen sink, but in a new home that is not the only place where a RO system can be installed, nor is it the most practical place. There is limited space under a kitchen sink and the person who spends the most time in the kitchen dislikes having to give up storage space because of an RO system. Additionally, servicing a system under a sink is more difficult and and leaks are more common due to space constraints. Where else can an RO system be installed? It is very practical to install one in the basement, garage or utility room. This makes service easier and results in no loss of space under the sink.

Ro Installation Services

Get the best price ro & water purifier installation, setup and wall mounting services. With same day quick doorstep services, Our expert home ro water purifier installers will be there when you need us.

Book Now
ro-service

Assemble the RO pre-filter

Open the pre-filter cap and insert the provided pre-filter candle. Firmly close the filter cap. Preferably use Teflon tape to achieve a complete seal. Now attach the elbow connectors on both sides of the pre-filter.

moduls

Installing RO Membrane

open the RO cabinet containing the rest of the filters. Inside spot the membrane filter. Remove the pipes connected to the cap of the filter. Open the cap and insert the membrane into the filter case. Then, firmly close the cap again.

moduls

Installing filter tap

Remove the nut and washer from behind the tap. Hold the tap into the opening provided in the water tank and place the washer from inside the tank onto the tap rear-end. Now, put the nut that you just removed to tighten the tap in place.

moduls

Assembling the tank

Now, assemble back the water tank and the filter compartment. Make sure all the screws are firmly tightened. start attaching the pipes of the RO purifier. Inlet of the pre-filter is connected to the feed water valve attached to the tap.

moduls

Book Your Service Now